LXR linux/drivers/pci/Makefile

   1#
   2# Makefile for the PCI bus specific drivers.
   3#
   4
   5obj-y           += access.o bus.o probe.o remove.o pci.o quirks.o slot.o \
   6                        pci-driver.o search.o pci-sysfs.o rom.o setup-res.o \
   7                        irq.o
   8obj-$(CONFIG_PROC_FS) += proc.o
   9
  10# Build PCI Express stuff if needed
  11obj-$(CONFIG_PCIEPORTBUS) += pcie/
  12
  13obj-$(CONFIG_HOTPLUG) += hotplug.o
  14
  15# Build the PCI Hotplug drivers if we were asked to
  16obj-$(CONFIG_HOTPLUG_PCI) += hotplug/
  17ifdef CONFIG_HOTPLUG_PCI
  18obj-y += hotplug-pci.o
  19endif
  20
  21# Build the PCI MSI interrupt support
  22obj-$(CONFIG_PCI_MSI) += msi.o
  23
  24# Build the Hypertransport interrupt support
  25obj-$(CONFIG_HT_IRQ) += htirq.o
  26
  27# Build Intel IOMMU support
  28obj-$(CONFIG_DMAR) += dmar.o iova.o intel-iommu.o
  29
  30obj-$(CONFIG_INTR_REMAP) += dmar.o intr_remapping.o
  31
  32obj-$(CONFIG_PCI_IOV) += iov.o
  33
  34#
  35# Some architectures use the generic PCI setup functions
  36#
  37obj-$(CONFIG_X86) += setup-bus.o
  38obj-$(CONFIG_ALPHA) += setup-bus.o setup-irq.o
  39obj-$(CONFIG_ARM) += setup-bus.o setup-irq.o
  40obj-$(CONFIG_PARISC) += setup-bus.o
  41obj-$(CONFIG_SUPERH) += setup-bus.o setup-irq.o
  42obj-$(CONFIG_PPC32) += setup-irq.o
  43obj-$(CONFIG_PPC) += setup-bus.o
  44obj-$(CONFIG_MIPS) += setup-bus.o setup-irq.o
  45obj-$(CONFIG_X86_VISWS) += setup-irq.o
  46obj-$(CONFIG_MN10300) += setup-bus.o
  47
  48#
  49# ACPI Related PCI FW Functions
  50#
  51obj-$(CONFIG_ACPI)    += pci-acpi.o
  52
  53# Cardbus & CompactPCI use setup-bus
  54obj-$(CONFIG_HOTPLUG) += setup-bus.o
  55
  56obj-$(CONFIG_PCI_SYSCALL) += syscall.o
  57
  58obj-$(CONFIG_PCI_STUB) += pci-stub.o
  59
  60ifeq ($(CONFIG_PCI_DEBUG),y)
  61EXTRA_CFLAGS += -DDEBUG
  62endif
  63