linux/net/can/Kconfig
<<
>>
Prefs
   1#
   2# Controller Area Network (CAN) network layer core configuration
   3#
   4
   5menuconfig CAN
   6        depends on NET
   7        tristate "CAN bus subsystem support"
   8        ---help---
   9          Controller Area Network (CAN) is a slow (up to 1Mbit/s) serial
  10          communications protocol which was developed by Bosch in
  11          1991, mainly for automotive, but now widely used in marine
  12          (NMEA2000), industrial, and medical applications.
  13          More information on the CAN network protocol family PF_CAN
  14          is contained in <Documentation/networking/can.txt>.
  15
  16          If you want CAN support you should say Y here and also to the
  17          specific driver for your controller(s) below.
  18
  19if CAN
  20
  21config CAN_RAW
  22        tristate "Raw CAN Protocol (raw access with CAN-ID filtering)"
  23        default y
  24        ---help---
  25          The raw CAN protocol option offers access to the CAN bus via
  26          the BSD socket API. You probably want to use the raw socket in
  27          most cases where no higher level protocol is being used. The raw
  28          socket has several filter options e.g. ID masking / error frames.
  29          To receive/send raw CAN messages, use AF_CAN with protocol CAN_RAW.
  30
  31config CAN_BCM
  32        tristate "Broadcast Manager CAN Protocol (with content filtering)"
  33        default y
  34        ---help---
  35          The Broadcast Manager offers content filtering, timeout monitoring,
  36          sending of RTR frames, and cyclic CAN messages without permanent user
  37          interaction. The BCM can be 'programmed' via the BSD socket API and
  38          informs you on demand e.g. only on content updates / timeouts.
  39          You probably want to use the bcm socket in most cases where cyclic
  40          CAN messages are used on the bus (e.g. in automotive environments).
  41          To use the Broadcast Manager, use AF_CAN with protocol CAN_BCM.
  42
  43config CAN_GW
  44        tristate "CAN Gateway/Router (with netlink configuration)"
  45        default y
  46        ---help---
  47          The CAN Gateway/Router is used to route (and modify) CAN frames.
  48          It is based on the PF_CAN core infrastructure for msg filtering and
  49          msg sending and can optionally modify routed CAN frames on the fly.
  50          CAN frames can be routed between CAN network interfaces (one hop).
  51          They can be modified with AND/OR/XOR/SET operations as configured
  52          by the netlink configuration interface known e.g. from iptables.
  53
  54source "drivers/net/can/Kconfig"
  55
  56endif
  57
lxr.linux.no kindly hosted by Redpill Linpro AS, provider of Linux consulting and operations services since 1995.