1# NGW100 customization 2 3if BOARD_ATNGW100_COMMON 4 5config BOARD_ATNGW100_MKII_LCD 6 bool "Enable ATNGW100 mkII LCD interface" 7 depends on BOARD_ATNGW100_MKII 8 help 9 This enables the LCD controller (LCDC) in the AT32AP7000. Since the 10 LCDC is multiplexed with MACB1 (LAN) Ethernet port, only one can be 11 enabled at a time. 12 13 This choice enables the LCDC and disables the MACB1 interface marked 14 LAN on the PCB. 15 16choice 17 prompt "Select an NGW100 add-on board to support" 18 default BOARD_ATNGW100_ADDON_NONE 19 20config BOARD_ATNGW100_ADDON_NONE 21 bool "None" 22 23config BOARD_ATNGW100_EVKLCD10X 24 bool "EVKLCD10X addon board" 25 depends on BOARD_ATNGW100_MKI || BOARD_ATNGW100_MKII_LCD 26 help 27 This enables support for the EVKLCD100 (QVGA) or EVKLCD101 (VGA) 28 addon board for the NGW100 and NGW100 mkII. By enabling this the LCD 29 controller and AC97 controller is added as platform devices. 30 31config BOARD_ATNGW100_MRMT 32 bool "Mediama RMT1/2 add-on board" 33 help 34 This enables support for the Mediama RMT1 or RMT2 board. 35 RMT provides LCD support, AC97 codec and other 36 optional peripherals to the Atmel NGW100. 37 38 This choice disables the detect pin and the write-protect pin for the 39 MCI platform device, since it conflicts with the LCD platform device. 40 The MCI pins can be reenabled by editing the "add device function" but 41 this may break the setup for other displays that use these pins. 42 43endchoice 44 45choice 46 prompt "LCD panel resolution on EVKLCD10X" 47 depends on BOARD_ATNGW100_EVKLCD10X 48 default BOARD_ATNGW100_EVKLCD10X_VGA 49 50config BOARD_ATNGW100_EVKLCD10X_QVGA 51 bool "QVGA (320x240)" 52 53config BOARD_ATNGW100_EVKLCD10X_VGA 54 bool "VGA (640x480)" 55 56config BOARD_ATNGW100_EVKLCD10X_POW_QVGA 57 bool "Powertip QVGA (320x240)" 58 59endchoice 60 61if BOARD_ATNGW100_MRMT 62source "arch/avr32/boards/atngw100/Kconfig_mrmt" 63endif 64 65endif # BOARD_ATNGW100_COMMON 66