linux/Documentation/fb/sh7760fb.txt
<<
>>
Prefs
   1SH7760/SH7763 integrated LCDC Framebuffer driver
   2================================================
   3
   40. Overview
   5-----------
   6The SH7760/SH7763 have an integrated LCD Display controller (LCDC) which
   7supports (in theory) resolutions ranging from 1x1 to 1024x1024,
   8with color depths ranging from 1 to 16 bits, on STN, DSTN and TFT Panels.
   9
  10Caveats:
  11* Framebuffer memory must be a large chunk allocated at the top
  12  of Area3 (HW requirement). Because of this requirement you should NOT
  13  make the driver a module since at runtime it may become impossible to
  14  get a large enough contiguous chunk of memory.
  15
  16* The driver does not support changing resolution while loaded
  17  (displays aren't hotpluggable anyway)
  18
  19* Heavy flickering may be observed
  20  a) if you're using 15/16bit color modes at >= 640x480 px resolutions,
  21  b) during PCMCIA (or any other slow bus) activity.
  22
  23* Rotation works only 90degress clockwise, and only if horizontal
  24  resolution is <= 320 pixels.
  25
  26files:   drivers/video/sh7760fb.c
  27        include/asm-sh/sh7760fb.h
  28        Documentation/fb/sh7760fb.txt
  29
  301. Platform setup
  31-----------------
  32SH7760:
  33 Video data is fetched via the DMABRG DMA engine, so you have to
  34 configure the SH DMAC for DMABRG mode (write 0x94808080 to the
  35 DMARSRA register somewhere at boot).
  36
  37 PFC registers PCCR and PCDR must be set to peripheral mode.
  38 (write zeros to both).
  39
  40The driver does NOT do the above for you since board setup is, well, job
  41of the board setup code.
  42
  432. Panel definitions
  44--------------------
  45The LCDC must explicitly be told about the type of LCD panel
  46attached.  Data must be wrapped in a "struct sh7760fb_platdata" and
  47passed to the driver as platform_data.
  48
  49Suggest you take a closer look at the SH7760 Manual, Section 30.
  50(http://documentation.renesas.com/eng/products/mpumcu/e602291_sh7760.pdf)
  51
  52The following code illustrates what needs to be done to
  53get the framebuffer working on a 640x480 TFT:
  54
  55====================== cut here ======================================
  56
  57#include <linux/fb.h>
  58#include <asm/sh7760fb.h>
  59
  60/*
  61 * NEC NL6440bc26-01 640x480 TFT
  62 * dotclock 25175 kHz
  63 * Xres                640     Yres            480
  64 * Htotal      800     Vtotal          525
  65 * HsynStart   656     VsynStart       490
  66 * HsynLenn    30      VsynLenn        2
  67 *
  68 * The linux framebuffer layer does not use the syncstart/synclen
  69 * values but right/left/upper/lower margin values. The comments
  70 * for the x_margin explain how to calculate those from given
  71 * panel sync timings.
  72 */
  73static struct fb_videomode nl6448bc26 = {
  74       .name           = "NL6448BC26",
  75       .refresh        = 60,
  76       .xres           = 640,
  77       .yres           = 480,
  78       .pixclock       = 39683,        /* in picoseconds! */
  79       .hsync_len      = 30,
  80       .vsync_len      = 2,
  81       .left_margin    = 114,  /* HTOT - (HSYNSLEN + HSYNSTART) */
  82       .right_margin   = 16,   /* HSYNSTART - XRES */
  83       .upper_margin   = 33,   /* VTOT - (VSYNLEN + VSYNSTART) */
  84       .lower_margin   = 10,   /* VSYNSTART - YRES */
  85       .sync           = FB_SYNC_HOR_HIGH_ACT | FB_SYNC_VERT_HIGH_ACT,
  86       .vmode          = FB_VMODE_NONINTERLACED,
  87       .flag           = 0,
  88};
  89
  90static struct sh7760fb_platdata sh7760fb_nl6448 = {
  91       .def_mode       = &nl6448bc26,
  92       .ldmtr          = LDMTR_TFT_COLOR_16,   /* 16bit TFT panel */
  93       .lddfr          = LDDFR_8BPP,           /* we want 8bit output */
  94       .ldpmmr         = 0x0070,
  95       .ldpspr         = 0x0500,
  96       .ldaclnr        = 0,
  97       .ldickr         = LDICKR_CLKSRC(LCDC_CLKSRC_EXTERNAL) |
  98                         LDICKR_CLKDIV(1),
  99       .rotate         = 0,
 100       .novsync        = 1,
 101       .blank          = NULL,
 102};
 103
 104/* SH7760:
 105 * 0xFE300800: 256 * 4byte xRGB palette ram
 106 * 0xFE300C00: 42 bytes ctrl registers
 107 */
 108static struct resource sh7760_lcdc_res[] = {
 109       [0] = {
 110               .start  = 0xFE300800,
 111               .end    = 0xFE300CFF,
 112               .flags  = IORESOURCE_MEM,
 113       },
 114       [1] = {
 115               .start  = 65,
 116               .end    = 65,
 117               .flags  = IORESOURCE_IRQ,
 118       },
 119};
 120
 121static struct platform_device sh7760_lcdc_dev = {
 122       .dev    = {
 123               .platform_data = &sh7760fb_nl6448,
 124       },
 125       .name           = "sh7760-lcdc",
 126       .id             = -1,
 127       .resource       = sh7760_lcdc_res,
 128       .num_resources  = ARRAY_SIZE(sh7760_lcdc_res),
 129};
 130
 131====================== cut here ======================================
 132
lxr.linux.no kindly hosted by Redpill Linpro AS, provider of Linux consulting and operations services since 1995.