1Using swap files with software suspend (swsusp)
   2        (C) 2006 Rafael J. Wysocki <>
   4The Linux kernel handles swap files almost in the same way as it handles swap
   5partitions and there are only two differences between these two types of swap
   7(1) swap files need not be contiguous,
   8(2) the header of a swap file is not in the first block of the partition that
   9holds it.  From the swsusp's point of view (1) is not a problem, because it is
  10already taken care of by the swap-handling code, but (2) has to be taken into
  13In principle the location of a swap file's header may be determined with the
  14help of appropriate filesystem driver.  Unfortunately, however, it requires the
  15filesystem holding the swap file to be mounted, and if this filesystem is
  16journaled, it cannot be mounted during resume from disk.  For this reason to
  17identify a swap file swsusp uses the name of the partition that holds the file
  18and the offset from the beginning of the partition at which the swap file's
  19header is located.  For convenience, this offset is expressed in <PAGE_SIZE>
  22In order to use a swap file with swsusp, you need to:
  241) Create the swap file and make it active, eg.
  26# dd if=/dev/zero of=<swap_file_path> bs=1024 count=<swap_file_size_in_k>
  27# mkswap <swap_file_path>
  28# swapon <swap_file_path>
  302) Use an application that will bmap the swap file with the help of the
  31FIBMAP ioctl and determine the location of the file's swap header, as the
  32offset, in <PAGE_SIZE> units, from the beginning of the partition which
  33holds the swap file.
  353) Add the following parameters to the kernel command line:
  37resume=<swap_file_partition> resume_offset=<swap_file_offset>
  39where <swap_file_partition> is the partition on which the swap file is located
  40and <swap_file_offset> is the offset of the swap header determined by the
  41application in 2) (of course, this step may be carried out automatically
  42by the same application that determines the swap file's header offset using the
  43FIBMAP ioctl)
  47Use a userland suspend application that will set the partition and offset
  48with the help of the SNAPSHOT_SET_SWAP_AREA ioctl described in
  49Documentation/power/userland-swsusp.txt (this is the only method to suspend
  50to a swap file allowing the resume to be initiated from an initrd or initramfs
  53Now, swsusp will use the swap file in the same way in which it would use a swap
  54partition.  In particular, the swap file has to be active (ie. be present in
  55/proc/swaps) so that it can be used for suspending.
  57Note that if the swap file used for suspending is deleted and recreated,
  58the location of its header need not be the same as before.  Thus every time
  59this happens the value of the "resume_offset=" kernel command line parameter
  60has to be updated.
  61 kindly hosted by Redpill Linpro AS, provider of Linux consulting and operations services since 1995.