linux/drivers/block/cciss_cmd.h
<<
>>
Prefs
   1#ifndef CCISS_CMD_H
   2#define CCISS_CMD_H
   3
   4#include <linux/cciss_defs.h>
   5
   6/* DEFINES */
   7#define CISS_VERSION "1.00"
   8
   9/* general boundary definitions */
  10#define MAXSGENTRIES            32
  11#define CCISS_SG_CHAIN          0x80000000
  12#define MAXREPLYQS              256
  13
  14/* Unit Attentions ASC's as defined for the MSA2012sa */
  15#define POWER_OR_RESET                  0x29
  16#define STATE_CHANGED                   0x2a
  17#define UNIT_ATTENTION_CLEARED          0x2f
  18#define LUN_FAILED                      0x3e
  19#define REPORT_LUNS_CHANGED             0x3f
  20
  21/* Unit Attentions ASCQ's as defined for the MSA2012sa */
  22
  23        /* These ASCQ's defined for ASC = POWER_OR_RESET */
  24#define POWER_ON_RESET                  0x00
  25#define POWER_ON_REBOOT                 0x01
  26#define SCSI_BUS_RESET                  0x02
  27#define MSA_TARGET_RESET                0x03
  28#define CONTROLLER_FAILOVER             0x04
  29#define TRANSCEIVER_SE                  0x05
  30#define TRANSCEIVER_LVD                 0x06
  31
  32        /* These ASCQ's defined for ASC = STATE_CHANGED */
  33#define RESERVATION_PREEMPTED           0x03
  34#define ASYM_ACCESS_CHANGED             0x06
  35#define LUN_CAPACITY_CHANGED            0x09
  36
  37/* config space register offsets */
  38#define CFG_VENDORID            0x00
  39#define CFG_DEVICEID            0x02
  40#define CFG_I2OBAR              0x10
  41#define CFG_MEM1BAR             0x14
  42
  43/* i2o space register offsets */
  44#define I2O_IBDB_SET            0x20
  45#define I2O_IBDB_CLEAR          0x70
  46#define I2O_INT_STATUS          0x30
  47#define I2O_INT_MASK            0x34
  48#define I2O_IBPOST_Q            0x40
  49#define I2O_OBPOST_Q            0x44
  50#define I2O_DMA1_CFG            0x214
  51
  52/* Configuration Table */
  53#define CFGTBL_ChangeReq        0x00000001l
  54#define CFGTBL_AccCmds          0x00000001l
  55
  56#define CFGTBL_Trans_Simple     0x00000002l
  57
  58#define CFGTBL_BusType_Ultra2   0x00000001l
  59#define CFGTBL_BusType_Ultra3   0x00000002l
  60#define CFGTBL_BusType_Fibre1G  0x00000100l
  61#define CFGTBL_BusType_Fibre2G  0x00000200l
  62typedef struct _vals32
  63{
  64        __u32   lower;
  65        __u32   upper;
  66} vals32;
  67
  68typedef union _u64bit
  69{
  70   vals32       val32;
  71   __u64        val;
  72} u64bit;
  73
  74/* Type defs used in the following structs */
  75#define QWORD vals32 
  76
  77/* STRUCTURES */
  78#define CISS_MAX_PHYS_LUN       1024
  79/* SCSI-3 Cmmands */
  80
  81#pragma pack(1) 
  82
  83#define CISS_INQUIRY 0x12
  84/* Date returned */
  85typedef struct _InquiryData_struct
  86{
  87  BYTE data_byte[36];
  88} InquiryData_struct;
  89
  90#define CISS_REPORT_LOG 0xc2    /* Report Logical LUNs */
  91#define CISS_REPORT_PHYS 0xc3   /* Report Physical LUNs */
  92/* Data returned */
  93typedef struct _ReportLUNdata_struct
  94{
  95  BYTE LUNListLength[4];
  96  DWORD reserved;
  97  BYTE LUN[CISS_MAX_LUN][8];
  98} ReportLunData_struct;
  99
 100#define CCISS_READ_CAPACITY 0x25 /* Read Capacity */ 
 101typedef struct _ReadCapdata_struct
 102{
 103  BYTE total_size[4];   /* Total size in blocks */
 104  BYTE block_size[4];   /* Size of blocks in bytes */
 105} ReadCapdata_struct;
 106
 107#define CCISS_READ_CAPACITY_16 0x9e /* Read Capacity 16 */
 108
 109/* service action to differentiate a 16 byte read capacity from
 110   other commands that use the 0x9e SCSI op code */
 111
 112#define CCISS_READ_CAPACITY_16_SERVICE_ACT 0x10
 113
 114typedef struct _ReadCapdata_struct_16
 115{
 116        BYTE total_size[8];   /* Total size in blocks */
 117        BYTE block_size[4];   /* Size of blocks in bytes */
 118        BYTE prot_en:1;       /* protection enable bit */
 119        BYTE rto_en:1;        /* reference tag own enable bit */
 120        BYTE reserved:6;      /* reserved bits */
 121        BYTE reserved2[18];   /* reserved bytes per spec */
 122} ReadCapdata_struct_16;
 123
 124/* Define the supported read/write commands for cciss based controllers */
 125
 126#define CCISS_READ_10   0x28    /* Read(10)  */
 127#define CCISS_WRITE_10  0x2a    /* Write(10) */
 128#define CCISS_READ_16   0x88    /* Read(16)  */
 129#define CCISS_WRITE_16  0x8a    /* Write(16) */
 130
 131/* Define the CDB lengths supported by cciss based controllers */
 132
 133#define CDB_LEN10       10
 134#define CDB_LEN16       16
 135
 136/* BMIC commands */
 137#define BMIC_READ 0x26
 138#define BMIC_WRITE 0x27
 139#define BMIC_CACHE_FLUSH 0xc2
 140#define CCISS_CACHE_FLUSH 0x01  /* C2 was already being used by CCISS */
 141
 142/* Command List Structure */
 143#define CTLR_LUNID "\0\0\0\0\0\0\0\0"
 144
 145typedef struct _CommandListHeader_struct {
 146  BYTE              ReplyQueue;
 147  BYTE              SGList;
 148  HWORD             SGTotal;
 149  QWORD             Tag;
 150  LUNAddr_struct    LUN;
 151} CommandListHeader_struct;
 152typedef struct _ErrDescriptor_struct {
 153  QWORD  Addr;
 154  DWORD  Len;
 155} ErrDescriptor_struct;
 156typedef struct _SGDescriptor_struct {
 157  QWORD  Addr;
 158  DWORD  Len;
 159  DWORD  Ext;
 160} SGDescriptor_struct;
 161
 162/* Command types */
 163#define CMD_RWREQ       0x00
 164#define CMD_IOCTL_PEND  0x01
 165#define CMD_SCSI        0x03
 166#define CMD_MSG_DONE    0x04
 167#define CMD_MSG_TIMEOUT 0x05
 168#define CMD_MSG_STALE   0xff
 169
 170/* This structure needs to be divisible by COMMANDLIST_ALIGNMENT
 171 * because low bits of the address are used to to indicate that
 172 * whether the tag contains an index or an address.  PAD_32 and
 173 * PAD_64 can be adjusted independently as needed for 32-bit
 174 * and 64-bits systems.
 175 */
 176#define COMMANDLIST_ALIGNMENT (8)
 177#define IS_64_BIT ((sizeof(long) - 4)/4)
 178#define IS_32_BIT (!IS_64_BIT)
 179#define PAD_32 (0)
 180#define PAD_64 (4)
 181#define PADSIZE (IS_32_BIT * PAD_32 + IS_64_BIT * PAD_64)
 182typedef struct _CommandList_struct {
 183  CommandListHeader_struct Header;
 184  RequestBlock_struct      Request;
 185  ErrDescriptor_struct     ErrDesc;
 186  SGDescriptor_struct      SG[MAXSGENTRIES];
 187        /* information associated with the command */ 
 188  __u32                    busaddr; /* physical address of this record */
 189  ErrorInfo_struct *       err_info; /* pointer to the allocated mem */ 
 190  int                      ctlr;
 191  int                      cmd_type; 
 192  long                     cmdindex;
 193  struct hlist_node list;
 194  struct request *         rq;
 195  struct completion *waiting;
 196  int    retry_count;
 197  void * scsi_cmd;
 198  char   pad[PADSIZE];
 199} CommandList_struct;
 200
 201/* Configuration Table Structure */
 202typedef struct _HostWrite_struct {
 203  DWORD TransportRequest;
 204  DWORD Reserved;
 205  DWORD CoalIntDelay;
 206  DWORD CoalIntCount;
 207} HostWrite_struct;
 208
 209typedef struct _CfgTable_struct {
 210  BYTE             Signature[4];
 211  DWORD            SpecValence;
 212  DWORD            TransportSupport;
 213  DWORD            TransportActive;
 214  HostWrite_struct HostWrite;
 215  DWORD            CmdsOutMax;
 216  DWORD            BusTypes;
 217  DWORD            Reserved; 
 218  BYTE             ServerName[16];
 219  DWORD            HeartBeat;
 220  DWORD            SCSI_Prefetch;
 221  DWORD            MaxSGElements;
 222  DWORD            MaxLogicalUnits;
 223  DWORD            MaxPhysicalDrives;
 224  DWORD            MaxPhysicalDrivesPerLogicalUnit;
 225} CfgTable_struct;
 226#pragma pack()   
 227#endif /* CCISS_CMD_H */
 228
lxr.linux.no kindly hosted by Redpill Linpro AS, provider of Linux consulting and operations services since 1995.