LXR linux/drivers/uwb/Kconfig

   1#
   2# UWB device configuration
   3#
   4
   5menuconfig UWB
   6        tristate "Ultra Wideband devices (EXPERIMENTAL)"
   7        depends on EXPERIMENTAL
   8        depends on PCI
   9        default n
  10        help
  11          UWB is a high-bandwidth, low-power, point-to-point radio
  12          technology using a wide spectrum (3.1-10.6GHz). It is
  13          optimized for in-room use (480Mbps at 2 meters, 110Mbps at
  14          10m). It serves as the transport layer for other protocols,
  15          such as Wireless USB (WUSB), IP (WLP) and upcoming
  16          Bluetooth and 1394
  17
  18          The topology is peer to peer; however, higher level
  19          protocols (such as WUSB) might impose a master/slave
  20          relationship.
  21
  22          Say Y here if your computer has UWB radio controllers (USB or PCI)
  23          based. You will need to enable the radio controllers
  24          below.  It is ok to select all of them, no harm done.
  25
  26          For more help check the UWB and WUSB related files in
  27          <file:Documentation/usb/>.
  28
  29          To compile the UWB stack as a module, choose M here.
  30
  31if UWB
  32
  33config UWB_HWA
  34        tristate "UWB Radio Control driver for WUSB-compliant USB dongles (HWA)"
  35        depends on USB
  36        help
  37          This driver enables the radio controller for HWA USB
  38          devices. HWA stands for Host Wire Adapter, and it is a UWB
  39          Radio Controller connected to your system via USB. Most of
  40          them come with a Wireless USB host controller also.
  41
  42          To compile this driver select Y (built in) or M (module). It
  43          is safe to select any even if you do not have the hardware.
  44
  45config UWB_WHCI
  46        tristate "UWB Radio Control driver for WHCI-compliant cards"
  47        depends on PCI
  48        help
  49          This driver enables the radio controller for WHCI cards.
  50
  51          WHCI is a specification developed by Intel
  52          (http://www.intel.com/technology/comms/wusb/whci.htm) much
  53          in the spirit of USB's EHCI, but for UWB and Wireless USB
  54          radio/host controllers connected via memory mapping (eg:
  55          PCI). Most of these cards come also with a Wireless USB host
  56          controller.
  57
  58          To compile this driver select Y (built in) or M (module). It
  59          is safe to select any even if you do not have the hardware.
  60
  61config UWB_WLP
  62        tristate "Support WiMedia Link Protocol (Ethernet/IP over UWB)"
  63        depends on UWB && NET
  64        help
  65          This is a common library for drivers that implement
  66          networking over UWB.
  67
  68config UWB_I1480U
  69        tristate "Support for Intel Wireless UWB Link 1480 HWA"
  70        depends on UWB_HWA
  71        select FW_LOADER
  72        help
  73         This driver enables support for the i1480 when connected via
  74         USB. It consists of a firmware uploader that will enable it
  75         to behave as an HWA device.
  76
  77         To compile this driver select Y (built in) or M (module). It
  78         is safe to select any even if you do not have the hardware.
  79
  80config UWB_I1480U_WLP
  81        tristate "Support for Intel Wireless UWB Link 1480 HWA's WLP interface"
  82        depends on UWB_I1480U &&  UWB_WLP && NET
  83        help
  84         This driver enables WLP support for the i1480 when connected via
  85         USB. WLP is the WiMedia Link Protocol, or IP over UWB.
  86
  87         To compile this driver select Y (built in) or M (module). It
  88         is safe to select any even if you don't have the hardware.
  89
  90endif # UWB
  91