LXR linux/drivers/pci/Makefile

   1#
   2# Makefile for the PCI bus specific drivers.
   3#
   4
   5obj-y           += access.o bus.o probe.o remove.o pci.o \
   6                        pci-driver.o search.o pci-sysfs.o rom.o setup-res.o \
   7                        irq.o vpd.o
   8obj-$(CONFIG_PROC_FS) += proc.o
   9obj-$(CONFIG_SYSFS) += slot.o
  10
  11obj-$(CONFIG_PCI_QUIRKS) += quirks.o
  12
  13# Build PCI Express stuff if needed
  14obj-$(CONFIG_PCIEPORTBUS) += pcie/
  15
  16obj-$(CONFIG_PCI_IOAPIC) += ioapic.o
  17
  18obj-$(CONFIG_HOTPLUG) += hotplug.o
  19
  20# Build the PCI Hotplug drivers if we were asked to
  21obj-$(CONFIG_HOTPLUG_PCI) += hotplug/
  22ifdef CONFIG_HOTPLUG_PCI
  23obj-y += hotplug-pci.o
  24endif
  25
  26# Build the PCI MSI interrupt support
  27obj-$(CONFIG_PCI_MSI) += msi.o
  28
  29# Build the Hypertransport interrupt support
  30obj-$(CONFIG_HT_IRQ) += htirq.o
  31
  32# Build Intel IOMMU support
  33obj-$(CONFIG_DMAR) += dmar.o iova.o intel-iommu.o
  34
  35obj-$(CONFIG_INTR_REMAP) += dmar.o intr_remapping.o
  36
  37obj-$(CONFIG_PCI_IOV) += iov.o
  38
  39#
  40# Some architectures use the generic PCI setup functions
  41#
  42obj-$(CONFIG_X86) += setup-bus.o
  43obj-$(CONFIG_ALPHA) += setup-bus.o setup-irq.o
  44obj-$(CONFIG_ARM) += setup-bus.o setup-irq.o
  45obj-$(CONFIG_PARISC) += setup-bus.o
  46obj-$(CONFIG_SUPERH) += setup-bus.o setup-irq.o
  47obj-$(CONFIG_PPC) += setup-bus.o
  48obj-$(CONFIG_MIPS) += setup-bus.o setup-irq.o
  49obj-$(CONFIG_X86_VISWS) += setup-irq.o
  50obj-$(CONFIG_MN10300) += setup-bus.o
  51obj-$(CONFIG_MICROBLAZE) += setup-bus.o
  52
  53#
  54# ACPI Related PCI FW Functions
  55#
  56obj-$(CONFIG_ACPI)    += pci-acpi.o
  57
  58# Cardbus & CompactPCI use setup-bus
  59obj-$(CONFIG_HOTPLUG) += setup-bus.o
  60
  61obj-$(CONFIG_PCI_SYSCALL) += syscall.o
  62
  63obj-$(CONFIG_PCI_STUB) += pci-stub.o
  64
  65ifeq ($(CONFIG_PCI_DEBUG),y)
  66EXTRA_CFLAGS += -DDEBUG
  67endif
  68