/*
 * ipmi_smi.h
 *
 * MontaVista IPMI system management interface
 *
 * Author: MontaVista Software, Inc.
 *         Corey Minyard <minyard@mvista.com>
 *         source@mvista.com
 *
 * Copyright 2002 MontaVista Software Inc.
 *
 *  This program is free software; you can redistribute it and/or modify it
 *  under the terms of the GNU General Public License as published by the
 *  Free Software Foundation; either version 2 of the License, or (at your
 *  option) any later version.
 *
 *
 *  THIS SOFTWARE IS PROVIDED ``AS IS'' AND ANY EXPRESS OR IMPLIED
 *  WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
 *  MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
 *  IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
 *  INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING,
 *  BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS
 *  OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND
 *  ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR
 *  TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE
 *  USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
 *
 *  You should have received a copy of the GNU General Public License along
 *  with this program; if not, write to the Free Software Foundation, Inc.,
 *  675 Mass Ave, Cambridge, MA 02139, USA.
 */

#ifndef __LINUX_IPMI_SMI_H
#define __LINUX_IPMI_SMI_H

#include <linux/ipmi_msgdefs.h>
#include <linux/proc_fs.h>
#include <linux/module.h>
#include <linux/device.h>
#include <linux/platform_device.h>
#include <linux/ipmi_smi.h>

/* This files describes the interface for IPMI system management interface
   drivers to bind into the IPMI message handler. */

/* Structure for the low-level drivers. */
typedef struct ipmi_smi *ipmi_smi_t;

/*
 * Messages to/from the lower layer.  The smi interface will take one
 * of these to send. After the send has occurred and a response has
 * been received, it will report this same data structure back up to
 * the upper layer.  If an error occurs, it should fill in the
 * response with an error code in the completion code location. When
 * asynchronous data is received, one of these is allocated, the
 * data_size is set to zero and the response holds the data from the
 * get message or get event command that the interface initiated.
 * Note that it is the interfaces responsibility to detect
 * asynchronous data and messages and request them from the
 * interface.
 */
struct ipmi_smi_msg {
        struct list_head link;

        long    msgid;
        void    *user_data;

        int           data_size;
        unsigned char data[IPMI_MAX_MSG_LENGTH];

        int           rsp_size;
        unsigned char rsp[IPMI_MAX_MSG_LENGTH];

        /* Will be called when the system is done with the message
           (presumably to free it). */
        void (*done)(struct ipmi_smi_msg *msg);
};

struct ipmi_smi_handlers {
        struct module *owner;

        /* The low-level interface cannot start sending messages to
           the upper layer until this function is called.  This may
           not be NULL, the lower layer must take the interface from
           this call. */
        int (*start_processing)(void       *send_info,
                                ipmi_smi_t new_intf);

        /* Called to enqueue an SMI message to be sent.  This
           operation is not allowed to fail.  If an error occurs, it
           should report back the error in a received message.  It may
           do this in the current call context, since no write locks
           are held when this is run.  If the priority is > 0, the
           message will go into a high-priority queue and be sent
           first.  Otherwise, it goes into a normal-priority queue. */
        void (*sender)(void                *send_info,
                       struct ipmi_smi_msg *msg,
                       int                 priority);

        /* Called by the upper layer to request that we try to get
           events from the BMC we are attached to. */
        void (*request_events)(void *send_info);

        /* Called when the interface should go into "run to
           completion" mode.  If this call sets the value to true, the
           interface should make sure that all messages are flushed
           out and that none are pending, and any new requests are run
           to completion immediately. */
        void (*set_run_to_completion)(void *send_info, int run_to_completion);

        /* Called to poll for work to do.  This is so upper layers can
           poll for operations during things like crash dumps. */
        void (*poll)(void *send_info);

        /* Enable/disable firmware maintenance mode.  Note that this
           is *not* the modes defined, this is simply an on/off
           setting.  The message handler does the mode handling.  Note
           that this is called from interrupt context, so it cannot
           block. */
        void (*set_maintenance_mode)(void *send_info, int enable);

        /* Tell the handler that we are using it/not using it.  The
           message handler get the modules that this handler belongs
           to; this function lets the SMI claim any modules that it
           uses.  These may be NULL if this is not required. */
        int (*inc_usecount)(void *send_info);
        void (*dec_usecount)(void *send_info);
};

struct ipmi_device_id {
        unsigned char device_id;
        unsigned char device_revision;
        unsigned char firmware_revision_1;
        unsigned char firmware_revision_2;
        unsigned char ipmi_version;
        unsigned char additional_device_support;
        unsigned int  manufacturer_id;
        unsigned int  product_id;
        unsigned char aux_firmware_revision[4];
        unsigned int  aux_firmware_revision_set : 1;
};

#define ipmi_version_major(v) ((v)->ipmi_version & 0xf)
#define ipmi_version_minor(v) ((v)->ipmi_version >> 4)

/* Take a pointer to a raw data buffer and a length and extract device
   id information from it.  The first byte of data must point to the
   netfn << 2, the data should be of the format:
      netfn << 2, cmd, completion code, data
   as normally comes from a device interface. */
static inline int ipmi_demangle_device_id(const unsigned char *data,
                                          unsigned int data_len,
                                          struct ipmi_device_id *id)
{
        if (data_len < 9)
                return -EINVAL;
        if (data[0] != IPMI_NETFN_APP_RESPONSE << 2 ||
            data[1] != IPMI_GET_DEVICE_ID_CMD)
                /* Strange, didn't get the response we expected. */
                return -EINVAL;
        if (data[2] != 0)
                /* That's odd, it shouldn't be able to fail. */
                return -EINVAL;

        data += 3;
        data_len -= 3;
        id->device_id = data[0];
        id->device_revision = data[1];
        id->firmware_revision_1 = data[2];
        id->firmware_revision_2 = data[3];
        id->ipmi_version = data[4];
        id->additional_device_support = data[5];
        if (data_len >= 11) {
                id->manufacturer_id = (data[6] | (data[7] << 8) |
                                       (data[8] << 16));
                id->product_id = data[9] | (data[10] << 8);
        } else {
                id->manufacturer_id = 0;
                id->product_id = 0;
        }
        if (data_len >= 15) {
                memcpy(id->aux_firmware_revision, data+11, 4);
                id->aux_firmware_revision_set = 1;
        } else
                id->aux_firmware_revision_set = 0;

        return 0;
}

/* Add a low-level interface to the IPMI driver.  Note that if the
   interface doesn't know its slave address, it should pass in zero.
   The low-level interface should not deliver any messages to the
   upper layer until the start_processing() function in the handlers
   is called, and the lower layer must get the interface from that
   call. */
int ipmi_register_smi(struct ipmi_smi_handlers *handlers,
                      void                     *send_info,
                      struct ipmi_device_id    *device_id,
                      struct device            *dev,
                      const char               *sysfs_name,
                      unsigned char            slave_addr);

/*
 * Remove a low-level interface from the IPMI driver.  This will
 * return an error if the interface is still in use by a user.
 */
int ipmi_unregister_smi(ipmi_smi_t intf);

/*
 * The lower layer reports received messages through this interface.
 * The data_size should be zero if this is an asyncronous message.  If
 * the lower layer gets an error sending a message, it should format
 * an error response in the message response.
 */
void ipmi_smi_msg_received(ipmi_smi_t          intf,
                           struct ipmi_smi_msg *msg);

/* The lower layer received a watchdog pre-timeout on interface. */
void ipmi_smi_watchdog_pretimeout(ipmi_smi_t intf);

struct ipmi_smi_msg *ipmi_alloc_smi_msg(void);
static inline void ipmi_free_smi_msg(struct ipmi_smi_msg *msg)
{
        msg->done(msg);
}

/* Allow the lower layer to add things to the proc filesystem
   directory for this interface.  Note that the entry will
   automatically be dstroyed when the interface is destroyed. */
int ipmi_smi_add_proc_entry(ipmi_smi_t smi, char *name,
                            read_proc_t *read_proc,
                            void *data);

#endif /* __LINUX_IPMI_SMI_H */