LXR linux/drivers/net/can/Kconfig

   1menu "CAN Device Drivers"
   2        depends on CAN
   3
   4config CAN_VCAN
   5        tristate "Virtual Local CAN Interface (vcan)"
   6        depends on CAN
   7        default N
   8        ---help---
   9          Similar to the network loopback devices, vcan offers a
  10          virtual local CAN interface.
  11
  12          This driver can also be built as a module.  If so, the module
  13          will be called vcan.
  14
  15config CAN_DEV
  16        tristate "Platform CAN drivers with Netlink support"
  17        depends on CAN
  18        default Y
  19        ---help---
  20          Enables the common framework for platform CAN drivers with Netlink
  21          support. This is the standard library for CAN drivers.
  22          If unsure, say Y.
  23
  24config CAN_CALC_BITTIMING
  25        bool "CAN bit-timing calculation"
  26        depends on CAN_DEV
  27        default Y
  28        ---help---
  29          If enabled, CAN bit-timing parameters will be calculated for the
  30          bit-rate specified via Netlink argument "bitrate" when the device
  31          get started. This works fine for the most common CAN controllers
  32          with standard bit-rates but may fail for exotic bit-rates or CAN
  33          source clock frequencies. Disabling saves some space, but then the
  34          bit-timing parameters must be specified directly using the Netlink
  35          arguments "tq", "prop_seg", "phase_seg1", "phase_seg2" and "sjw".
  36          If unsure, say Y.
  37
  38config CAN_AT91
  39        tristate "Atmel AT91 onchip CAN controller"
  40        depends on CAN_DEV && ARCH_AT91SAM9263
  41        ---help---
  42          This is a driver for the SoC CAN controller in Atmel's AT91SAM9263.
  43
  44source "drivers/net/can/sja1000/Kconfig"
  45
  46source "drivers/net/can/usb/Kconfig"
  47
  48config CAN_DEBUG_DEVICES
  49        bool "CAN devices debugging messages"
  50        depends on CAN
  51        default N
  52        ---help---
  53          Say Y here if you want the CAN device drivers to produce a bunch of
  54          debug messages to the system log.  Select this if you are having
  55          a problem with CAN support and want to see more of what is going
  56          on.
  57
  58endmenu
  59