LXR linux/drivers/w1/masters/Kconfig

   1#
   2# 1-wire bus master configuration
   3#
   4
   5menu "1-wire Bus Masters"
   6
   7config W1_MASTER_MATROX
   8        tristate "Matrox G400 transport layer for 1-wire"
   9        depends on PCI
  10        help
  11          Say Y here if you want to communicate with your 1-wire devices
  12          using Matrox's G400 GPIO pins.
  13
  14          This support is also available as a module.  If so, the module
  15          will be called matrox_w1.ko.
  16
  17config W1_MASTER_DS2490
  18        tristate "DS2490 USB <-> W1 transport layer for 1-wire"
  19        depends on USB
  20        help
  21          Say Y here if you want to have a driver for DS2490 based USB <-> W1 bridges,
  22          for example DS9490*.
  23
  24          This support is also available as a module.  If so, the module
  25          will be called ds2490.ko.
  26
  27config W1_MASTER_DS2482
  28        tristate "Maxim DS2482 I2C to 1-Wire bridge"
  29        depends on I2C && EXPERIMENTAL
  30        help
  31          If you say yes here you get support for the Maxim DS2482
  32          I2C to 1-Wire bridge.
  33
  34          This driver can also be built as a module.  If so, the module
  35          will be called ds2482.
  36
  37config W1_MASTER_DS1WM
  38        tristate "Maxim DS1WM 1-wire busmaster"
  39        depends on W1 && ARM
  40        help
  41          Say Y here to enable the DS1WM 1-wire driver, such as that
  42          in HP iPAQ devices like h5xxx, h2200, and ASIC3-based like
  43          hx4700.
  44
  45config W1_MASTER_GPIO
  46        tristate "GPIO 1-wire busmaster"
  47        depends on GENERIC_GPIO
  48        help
  49          Say Y here if you want to communicate with your 1-wire devices using
  50          GPIO pins. This driver uses the GPIO API to control the wire.
  51
  52          This support is also available as a module.  If so, the module
  53          will be called w1-gpio.ko.
  54
  55endmenu
  56
  57